THIS VAN HAS SOLD! I have a opening for January 2021 if you are interested in a similar build. The cost for this build as shown is about $40,000 not including the van. That price can change based on your needs.


This build uses 80/20 extruded aluminum construction. This gives you the benefit of a very STRONG build while also saving weight. You can move the entire van by grabbing onto the galley framing and trying to shake it. Attempt that with some other vans and you are likely to break their cabinet completely. The strength and durability of this aluminum framing bolted into the van wall is unmatched. And gives you peace of mind knowing your cabinetry will never break on your adventures. Built to last!

Only quality components are used. Make sure you compare apples to apples when looking for your next adventure vehicle. Below is a list of some features of this campervan build. If you have any questions please contact me and thank you for looking!

Email me at cmeyerpa@gmail.com



- Cedar ceiling

- Thinsulate SM600L insulation

- 32" clearance under the bed

- Full size bed with padded marine vinyl walls

- 400ah of Battleborn lithium

- Victron 3000w Inverter/Charger

- Victron 100/50 MPPT Solar Controller

- Victron Orion 30a alternator charger

- Victron BMV-712 battery monitor

- 570w of solar

- Ancor Marine stranded tinned copper wire

- 15 amp shore power

- Outdoor shower

- 30 gallon fresh water. 15 gallon grey water

- Bosch 2.5g electric hot water heater

- Two Maxxair fans

- 12v Danfoss Compressor fridge

- Portable induction cooktop

- Maple dovetail drawer boxes and fronts in the galley

- Acrylic sliding doors on upper cabinets

- Corian countertop

- Lifeproof vinyl flooring

- Thetford Porta Potti

- Ruvati stainless sink